16 Accessories
16.1 Heating
DANGER
Risk of death resulting from electric shock.
► Ensure that the electrical power supply is de-energized and is secured against being switched
back on.
► Observe the operating instructions of the electrical components.
Fig.9: Tubular pipe cartridge with heating sleeve
Envelop the flowmeter with the heating sleeve with tubular pipe cartridge lying on the inside.
Notice If a tubular pipe cartridge is used, the manufacturer recommends insulating the flowmeter and heating
system in order to avoid radiation losses.
Installing the fluid heating system
Personnel qualification: o Fitter
Personal protective equipment: o Work clothing
o Protective gloves
o Safety boots
ATTENTION
Damage to equipment through the use of water or steam as a heating liquid.
► Use a suitable heating liquid, such as heat transfer oil.
Envelop the flowmeter with heating jack.
Installing the trace heating
Notice Before installing trace heating provided by the customer, contact the manufacturer.
Personnel qualification: o Fitter
Personal protective equipment: o Work clothing
o Protective gloves
o Safety boots
ATTENTION
Defective components through the maximum temperature being exceeded.
► Do not heat the pick up, temperature sensor, junction box and associated cables above the tem-
perature specified in the associated operating instructions.
50
OIO 14en-GB Edition 2020-01
Operating instructions
To Next Page
Loading...
