3 Identification
2.3 Obligations of the operator-owner
2.3 Obligations of the operator-owner
The operator-owner is the person who operates the product commercially or permits a third party to
use it and who bears the legal responsibility for the product, the protection of the personnel and third
parties during its operation.
The product is used in industrial applications. The operator-owner is therefore subject to the statutory
obligations concerning occupational health and safety.
In addition to the safety instructions in these instructions, the regulations on safety, accident prevention
and environmental protection respectively valid for the range of application of the product are to be ob-
served.
2.4 Safety instructions
2.4.1 Fundamental safety instructions
The following safety instructions must be observed strictly:
o Read these operating instructions carefully and observe them.
o Read the operating instructions for the electronic unit and the sensors carefully and observe them.
o Have work only carried out by qualified personnel / trained personnel.
o Wear personal protective equipment and work carefully.
o Pumped liquids can be subject to high pressure and can result in personal injury and damage to
property in case of incorrect operation or damaged components.
o Pumped liquids can be hot, poisonous, combustible and caustic.
o Observe the associated data sheets and safety regulations when handling dangerous materials.
o Avoid skin contact with system parts carrying liquids at operating temperatures exceeding 60°C.
o Collect any discharging pumped liquid safely and dispose of it in an environmentally compatible
manner in accordance with the applicable local regulations. Neutralize residues.
o Keep the mounting surfaces, scaffolding, ladders, lifting platforms and tools clean in order to pre-
vent slipping or stumbling.
o If pressurized or energized components are damaged, shut down the flowmeter immediately. Re-
place the components or flowmeter.
3 Identification
3.1 Type code
OMG-020.CABABA.0001
3
4
5
2
7
6
8
9
1
Fig.1: Type code
1 Series
2 Size
3 Sensor equipment (pick up)
4 Function of the sensor equipment
5 Material of bearing
6 Material of seal
7 Mechanical connection
8 Electrical connection
9 Version index
6
OIO 14en-GB Edition 2020-01
Operating instructions
To Next Page
Loading...
Need help?
General
