Kramer FC-18 - FC-18 Automatic HDMI Signal Control Configuration; FC-18 Video & Audio Page Settings

Kramer Electronics Ltd.
FC-18 – Controlling the Display via FC-18
20
To control the display automatically via HDMI:
1. Connect the HDMI port to the CEC-enabled display.
Figure 20: Sending Automatic Commands via HDMI Connector
2. In the Navigation pane, click Video & Audio. The Video & Audio page appears.
Figure 21: Video & Audio Page – Setting 5V Off Signal-Loss Delay Time
3. Enter the 5V powering off delay time and click Set.
12