12
Engine
Repairs
In case of damage or problems with the engine, please contact your local Krämer Motorcycles
dealer.
Recommended Engine Maintenance
• See Service Schedule on pg. 29
Engine Modes / Workmodes
• NOTE: The Engine Mode can be changed at any moment during riding or also standing.
Using the Engine Mode selector button
E
three different Engine Modes
A
can be selected. Each mode
adjusts the throttle response as well as the engine braking.
• Sun + Arrow Up: Dry throttle map with more engine braking
• Sun + Arrow down: Dry throttle map with less engine braking
• Rain: Wet throttle map with less engine braking and rain speci ed traction control
Pit Limiter
• NOTE: The Pit Limit mode limits the speed of the motorcycle to 60 km/h (37 mph).
1. Before using the Pit Limit mode, make sure that the engine is running.
2. Engage Pit Limit mode by pressing the button
I
on L.H. handlebar for two seconds. Exit Pit Limit
mode by pressing the button again.
3. When engaged, the dash logger will display a “PIT LIMITER” message.
Engine
Traction Control setting
Pit Limiter Button
Engine Mode selection
I
E
Traction Control
• NOTE: Traction Control setting can be changed at any moment during riding or also standing.
The Traction Control (TC) can be adjusted from minimum to maximum in ten steps overall. The neutral
setting is “0”, less TC intervention is covered by steps “-1” to “OFF” whereas increased TC intervention
is covered by stepts “1” to “MAX”. To nd the preferred setting in both dry and wet conditions, start with
“MAX” and then slowly adjust the TC intervention until feeling comfortable.
1. Choose to adjust the TC by pressing the Trimmer context button
H
.
2. Use the + / - buttons
F
and
G
to select the preferred TC setting shown by
B
.
H
F
G
Wheelie Control
• NOTE: Wheelie Control mode can be changed at any moment during riding or also standing.
The Wheelie Control can be adjusted from minimum to maximum in six steps overall (“OFF” to “5”). When
turned on, it will reduce the lift of front wheel while hard acceleration.
1. Choose to adjust the Wheelie Control by pressing the Trimmer context button
H
.
2. Use the + / - buttons
F
and
G
to select the preferred Wheelie Control setting, the indicator
C
shows whether the Wheelie Control (=AWM eg. Anti Wheelie Mode) is turned on or off.
Wheelie Control setting
H
F
G
A
B
C
Repack the Muffler
• Every 1.000 km or when it is burned out. The muf er is burned
out when the bike is signi cantly louder than normal. Empty
muf er reduces engine performance and can lead to cracks in the
exhaust.
• Part Number for the Exhaust Service in the KMC Onlineshop:
320501001S
To Next Page
Loading...
Need help?
General