9
Maintenance / Service
Service Schedule
For a detailed listing of service schedule see the chart on pg. 29.
Krämer Motorcycles Onlineshop
If any part of your GP2-890RR needs to be replaced because of wear or damage, spare parts can be
found in the Krämer Motorcycles Onlineshop:
www.kmc-shop.com
Checking the Engine Oil Level
Check the engine oil level at normal engine
operating temperature.
1. Stand the motorcycle upright on a level surface.
2. Start engine and warm to normal operating
temperature. Turn off the engine, wait one
minute before checking the level.
3. Check the engine oil in the sight glass window
A
.
The level must be between the lower and upper
markings beside the window.
4. If needed, add oil, at oil ller
B
, to speci ed
level.
Oil Level Window (R.H. side of engine)
Upper Level
Lower Level
A
Changing the Engine Oil & Filter, and Cleaning the Oil Screens
Oil Draining
1. Raise the rear of the motorcycle on a rear lift
stand [See pg. 7].
2. Remove the right side fairing and lower fairing
[See pg. 15].
3. Start the engine and warm it to normal
operating temperature.
4. Remove the safety wire.
5. Place a drain container under the engine.
6. Remove the oil ller cap
B
from the clutch
cover.
7. Remove the oil drain plugs
C
along with the
magnets, the o-rings, and the oil screens.
8. Completely drain the engine oil.
9. Inspect the magnets, o-rings and
the oil screens for any metal shavings,
and thoroughly clean the plugs, screens, and
magnets.
Oil Filter Changing
1. Remove the screws from the oil lter cover
D
,
and remove cover with the o-ring.
2. Pull out the lter. Allow the remaining engine
oil to drain.
3. Thoroughly clean the parts and sealing
surfaces.
4. Insert the new oil lter.
5. Coat the o-ring with oil, position the oil lter
cover, and reinstall the cover screws.
6. Torque the cover screws – 6 Nm (4.4 lb-ft).
Oil Changing
1. Drain the oil
2. Change the oil lter
3. Install the oil drain plugs
C
, the magnets, the
o-rings and the oil screens.
4. Tighten the oil screen plugs
C
–
15 Nm (11.1 lb-ft).
5. Fill up engine oil at ller
B
– 3.2 L. (3.4 qt.)
of Motorex 15W/50 Racing Pro 4T oil.
6. Install and tighten the ller plug
B
.
7. Let the engine run for approx. 30 seconds,
check thoroughly for leaks.
8. Check the engine oil level
A
and add oil if
necessary.
9. Rewire the locking safety wire following the
instructions on pg. 32.
Oil Filter, Drain Plugs with Screens and Magnets (L.H. side of engine)
Oil Filler Oil Filter Screws
C
Maintenance / Service
Safety wire oil drain plugs
C
, oil lter cover
D
, and
ller plug
B
B
D
To Next Page
Loading...
Need help?
General