set tx N1 uart 1 command [N2]
set tx N1 uart 1 command [N2]
Transmit the specified command data via the serial port on the specified transmitter.
N1 = 1~128 ....................... [Transmitter device ID]
N2 = {Command data} ...... [ASCII text]
Note: To transmit hex data, each ASCII hex pair (octet) must be preceded by “\x”. For
example a carriage return would be “\x0D”.
set rx N1 uart 1 command [N2]
set rx N1 uart 1 command [N2]
Transmit the specified command data via the serial port on the specified receiver.
N1 = 1~128 ....................... [Receiver device ID]
N2 = {Command data} ...... [ASCII text]
Note: To transmit hex data, each ASCII hex pair (octet) must be preceded by “\x”. For
example a carriage return would be “\x0D”.
set all tx uart command [N1]
set all tx uart command [N1]
Transmit the specified command data via the serial port on all transmitters.
N1 = {Command data} ...... [ASCII text]
Note: To transmit hex data, each ASCII hex pair (octet) must be preceded by “\x”. For
example a carriage return would be “\x0D”.
set all rx uart command [N1]
set all rx uart command [N1]
Transmit the specified command data via the serial port on all receivers.
N1 = {Command data} ...... [ASCII text]
Note: To transmit hex data, each ASCII hex pair (octet) must be preceded by “\x”. For
example a carriage return would be “\x0D”.
set voip N1 uart route N2
set voip N1 uart route N2
Route the specified transmitter or receiver’s serial port Rx pin to the serial port Tx pin on the
specified transmitter or receiver.
Available values for N1:
tx1~tx128 .............................
[Transmitter device ID (Tx pin)]
rx1~rx128 .............................
[Receiver device ID (Tx pin)]
Available values for N2:
tx1~tx128 .............................
[Transmitter device ID (Rx pin)]
rx1~rx128 .............................
[Receiver device ID (Rx pin)]
To Next Page
Loading...
Need help?
General