Kramer KDS-8-MNGR User Manual

Kramer Electronics Ltd.
KDS-8-MNGR – Telnet Control
67
set all voip uart route N1
set all voip uart route N1
Route the specified transmitter or receiver’s serial port Rx pin to all AVoIP devices’ serial
port Tx pins.
Available values for N1:
tx1~tx128 ............................. [Transmitter device ID]
rx1~rx128 ............................. [Receiver device ID]
set tx N1 ir 1 command [N2]
set tx N1 ir 1 command [N2]
Transmit the specified IR data via the IR output on the specified transmitter.
N1 = 1~128 ....................... [Transmitter device ID]
N2 = {IR ASCII hex data} .. [Pronto format IR data]
set rx N1 ir 1 command [N2]
set rx N1 ir 1 command [N2]
Transmit the specified IR data via the IR output on the specified receiver.
N1 = 1~128 ....................... [Receiver device ID]
N2 = {IR ASCII hex data} .. [Pronto format IR data]
set all tx ir command [N1]
set all tx ir command [N1]
Transmit the specified IR data via the IR outputs on all transmitters.
N1 = {IR ASCII hex data} .. [Pronto format IR data]
set all rx ir command [N1]
set all rx ir command [N1]
Transmit the specified IR data via the IR outputs on all receivers.
N1 = {IR ASCII hex data} .. [Pronto format IR data]
set voip N1 ir route N2
set voip N1 ir route N2
Route the specified transmitter or receiver’s IR input to the IR output on the specified
transmitter or receiver.
Available values for N1:
tx1~tx128 ............................. [Transmitter device ID (IR output)]
rx1~rx128 ............................. [Receiver device ID (IR output)]
Available values for N2:
tx1~tx128 ............................. [Transmitter device ID (IR input)]
rx1~rx128 ............................. [Receiver device ID (IR input)]

Kramer KDS-8-MNGR Specifications

General

Brand	Kramer
Model	KDS-8-MNGR
Category	Server
Language	English