Kramer VS-42H2

Kramer Electronics Ltd.
VS-42H2 – Configuring and Maintaining VS-42H2
13
Configuring and Maintaining
VS-42H2
Setting DIP-Switches
The eight DIP-switches located on the back panel dictate the behavior of the VS-42H2.
Figure 8: DIP-Switches
#
Feature
Description
1
Input 1 HDCP support
Off (up) – Input 1 does not support HDCP.
On (down) – Input 1 is HDCP compliant.
2
Input 2 HDCP support
Off (up) – Input 2 does not support HDCP.
On (down) – Input 2 is HDCP compliant.
3
Input 3 HDCP support
Off (up) – Input 3 does not support HDCP.
On (down) – Input 3 is HDCP compliant.
4
Input 4 HDCP support
Off (up) – Input 4 does not support HDCP.
On (down) – Input 4 is HDCP compliant.
5
Output 1 switching mode
Off (up) – Output 1: Manual switching.
On (down) – Output 1: Automatic switching.
6
Output 1 switching type
Off (up) – Output 1: Last Connected mode (if DIP 5 is on).
On (down) – Output 1: Priority mode (if DIP 5 is on).
7
Output 2 switching mode
Off (up) – Output 2: Manual switching.
On (down) – Output 2: Automatic switching.
8
Output 2 switching type
Off (up) – Output 2: Last Connected mode (if DIP 7 is on).
On (down) – Output 2: Priority mode (if DIP 7is on).
The DIP-switch status is sampled when the device is reset. The unit must be powered off and
on for the new settings to activate.
15