Resetting VS-42H2 to Factory Default Settings
To reset the device to factory default settings:
1. Unplug the device to power down VS-42H2.
VS-42H2 powers down.
2. While holding down the Reset button on the rear panel using a sharp object, power
on the device and wait a few seconds.
The device is reset to its factory settings.
Upgrading Firmware
VS-42H2 can be upgraded via any of the following:
• Mini USB
• RS-232
• Ethernet
Use the Kramer K-UPLOAD software to upgrade the firmware via the VS-42H2 USB
Connector , or via RS-232 (set DIP-switch 6 to Off (up position) to allow RS-232 to
control/program the device), or via the ETHERNET RJ-45 Connector .
The latest version of K-UPLOAD and installation instructions can be downloaded from our
website at: www.kramerav.com/support/product_downloads.asp.
Note that in order to use the micro USB port, you need to install the Kramer USB driver,
available at: www.kramerav.com/support/product_downloads.asp.
To Next Page
Loading...
