Krone EasyCut 2801 CV - Function of the Switches on the Control Unit

Special equipment
102
Pos: 37.21 /Übersc hriften/Überschrif ten 2/F-J/Fu nktion der Sc halter Bedienein heit @ 35\mod_ 12579226028 63_78.docx @ 3 33387 @ 3 @ 1
14.8 Function of the switches on the control unit
Pos: 37.22 /BA/Be dienung /Eas yCut/Funktion d erS chalter Be dieneinheit EC 2 800/3200 @ 10\mod_122215 5191780_78.doc x@ 139011 @ @ 1
Fig. 65:
The control unit can be used to adjust the speed of the cross conveyor. The following table
explains the function of the individual switches.
Item Designation Function
1 Pilot lamp (red) Lit when the control unit is turned on.
2 Flip switch Top: Control unit on
Bottom: Control unit off
3 Rotary potentiometer The rotary potentiometer can be used to adjust the speed of
the cross-conveyor belt.
clockwise = faster
anticlockwise = slower
Pos: 37.23 /BA/--- ------ ------Seitenumbruch---- ------------ @ 0\m od_1196175311 226_0.docx @ 4 165 @ 3 @ 1