Settings
56
Pos: 24.40 /Übersc hriften/Überschrif ten 3/A-E/Ein stellung bei Sch wadablage @ 3 \mod_1204 713732476_78. docx @ 72183 @ 33 @ 1
9.7.3 Adjustment for Swathing
Pos: 24.41 /Übersc hriften/Überschrif ten 3/P-T/So nderausrüstung @ 0\mod_ 1201161230852 _78.docx @ 510 84 @ 3 @ 1
9.7.4 Special equipment
Pos: 24.42 /BA/Ei nstellungen/M ähwerke/Schwa dbreite / Breita blage/Einstellung der Schwad ablage Bild EC2 80/320 CV / B 1000 CV @ 10 3\mod_13317 93832879_78.d ocx @ 938098 @ @ 1
A
B
EC-371-1
Fig. 33
Pos: 24.43 /BA/Sic herheit/Gefahre nhinweise/Sic herheitshinweise am Anfang d es Kapitels beac hten @ 101\ mod_1330611 811687_78.docx @ 897943 @ @ 1
• Observe the safety instructions at the beginning of the section.
Pos: 24.44 /BA/Ei nstellungen/M ähwerke/Schwa dbreite / Breita blage/Einstellung der Schwad ablageT ext EC R 280/320 CV / B 1000 CV @ 9 1\mod_1 326180780237_78.d ocx @ 7772 59 @ @ 1
The swath width can be adjusted to the crop
To do this:
• Loosen the ring nut (1) (right and left machine side)
• Adjust the swath flaps (2) (ensure that right and left machine side have the same settings)
• to the outside “A” = wide swath
• to the inside “B” = close swath
• Tighten ring nut (1)
Pos: 24.45 /BA/Ei nstellungen/M ähwerke/Schwa dbreite / Breita blage/Schwad klappenverlängeru ng (optional) @ 131\mod_13 47599482412 _78.docx @ 11 63175 @ @ 1
Swath Flap Extension (Optional)
Pos: 24.46 /BA/Ei nstellungen/M ähwerke/Schwa dbreite / Breita blage/Schwad klappenverlängeru ng einstellen @ 60\mod_1297 853406559_7 8.docx @ 56 1524@ @ 1
The swath width can also be set using the extension on the swath flaps.
To do this:
• Loosen the star knob (1) (right and left sides of machine)
• Set swath flap extension (3)
• Tighten the star knobs (1)
Pos: 24.47 /BA/Ei nstellungen/M ähwerke/Schwa dbreite / Breita blage/Kreuzgri ffe Hinweis @ 59\ mod_129743 1749350_78.doc x@ 558246 @ 3 @ 1
Note
The star knobs may work loose due to vibrations, possibly resulting in the loss of the star
knobs, screws and swath plates.
• Manually tighten star knobs as tight as possible to ensure that they cannot work loose
during operation due to vibrations
Pos: 24.48 /BA/--- ------ ------Seitenumbruch---- ------------ @ 0\m od_1196175311 226_0.docx @ 4 165 @ @ 1
To Next Page
Loading...
