Maintenance
71
Pos: 26.34.10 / BA/Wartung/Mä hwerke/Öl kontrolleM ähholm Eas ycut @ 3\mo d_120472320693 0_78.docx @ 7 2428 @ @ 1
• Allow the machine to run briefly. Do not leave the driver’s cab until the cutting discs/blade
drums have come to a complete stop
EC-0-003
Fig. 42:
Check the oil level before every use
• Remove the oil level inspection screw (1) from the cutting disc hub
• The oil level must be up to the bore hole. If required, top up the oil (SAE 90)
• Screw in the oil level inspection screw (1) again and tighten securely
Pos: 26.35 /BA/--- ------ ------Seitenumbruch---- ------------ @ 0\m od_1196175311 226_0.docx @ 4 165 @ @ 1
To Next Page
Loading...
