Krone Swadro 800/26

To Next Page

To Previous Page

IV - 10

Handling the swather when in use

SW700029

• Remove chocks (1) from chassis and place them in

front and/or behind the wheels.

• Lower the lower link until the swather rests on the

support. Uncouple the swather.

Main Page

Table of Contents5
General Information9
Proper Use9
Specifications9
Manufacturer's Address9
Certification9
Identification9
Data Required for Inquiries and Orders9
Proper Use10
Safety13
Identifying Safety Instructions in the Operating Manual13
Safety Instructions and Accident Prevention Regulations13
Personnel Qualification and Training13
Failure to Follow the Safety Instructions13
Working in a Safety Conscious Manner13
Trailer Implements14
Power Take-Off Operation14
Hydraulic System15
Tyres15
Working in the Vicinity of Power Transmission Lines15
Maintenance16
Introduction17
Location of the Safety Labels on the Machine, Containing Technical Safety Information on the Machine17
Location of the General Information Signs on the Machine20
General Preparation for Use21
Special Safety Instructions21
Preparations on the Tractor21
Lifting Device on the Tractor (Three-Point Linkage)21
Attachment of Swather to Tractor22
Attachment to the Tractor Lower Link Arms22
Hydraulic Connection Swadro 70023
Hydraulics Connection23
Hydraulic Single-Rotor Lifting System23
Lighting Cable Connection24
Connecting the Electric Control Unit (Optional)24
Function of the Switches on the Control Unit (Optional)25
Connecting the PTO Shaft26
Length Adaption26
Transport of the Swather on Public Roads27
Preparing the Rotary Swather for Use27
Genera27
Handling the Swather When in Use29
Mounting on the Tractor29
Overload Protection Feature29
Converting from Transport to Working Position30
Lowering the Rotor Arms - Mechanically30
Lowering the Rotor Arms - Hydraulic Single-Rotor Lifting System30
Lowering the Rotor Arms - Electrically (Optional30
Folding the Tine Arms into Working Position31
Moving the External Guard Bars into Working Position32
Separate Actuation of the Left-Hand/Right-Hand Swather Disk32
Hydraulic Single-Rotor Lifting System32
Electrical Operation Device (Optional32
Conversion from Working to Transport Position33
Moving the External Guard Bars into Transport Position33
Folding the Tine Arms into Transport Position34
Lifting the Rotor Arms - Mechanically35
Lifting the Rotor Arms - Hydraulic Single-Rotor Lifting System35
Lifting the Rotor Arms - Electrically (Optional35
Securing the Tine Tips (Transport Position and Parked Swather36
Driving in Sloping36
Removal from Tractor37
Basic Setting39
Height of the Tractor Lower Link Arms39
Setting the Working Depth39
Setting the Operating Width Electrical40
Setting the Operating Width Electrical / Mechanic41
Setting the Lateral Inclination of the Swather Disk Chassis41
Adjusting the Direction of Travel42
Travel Speed and Drive R.p.M42
Care and Maintenance43
Special Safety Instructions43
General Instructions43
Tyres44
Air Pressure44
Wheel Fixings44
Replacing the Tine Arms (in Case of Repair)45
Replacing the Hydraulic Hose Lines45
Lubrication47
Universal Drive Shaft47
Bearings on the Swather47
Lubrication Chart49
Accessories51
Tine Loss Prevention Feature (Accessory)51
Chain for Limiting Depth of Lower Link Arms (Accessory)51
Winter Storage53
Starting up Again55
Faults - Causes and Remedy57
Special Safety Instructions57
General Faults, Causes and Remedy57
A1 Appendix To the Operating Manual59
A1.1 Preparations59
A1.2 Changing Wheels on the Chassis59
A1.3 Installing the Swath Rubber59
A1.4 Attaching the Warning Signs60
A1.5 Installing the Lighting System60

Krone Swadro 800/26 - Page 38

Table of Contents

Related product manuals