Driving and Transport
38
Pos: 18.5 /BA/Fa hren und Transp ort/Schwader/V orbereitung für d en Transport S wadro 807_80 9_810_907 @ 76\mod_130976 5675876_78.doc @ 664143
SW9070015
1
1
1
2
Swadro 907
SW810004_1
1
1
Swadro 807, Swadro 809, Swadro 810
Fig. 12
• Switch off the control unit (Swadro 810; Swadro 907 optional)
• Fold over the folding tine arms (right and left side of machine) (see section on Operation
"Swivelling the Tine Arms into Transport Position").
• Fix the rotor in place (see section on Operation "Swivelling the Tine Arms into Transport
Position").
• Move the swath cloth to transport position (see section on Operation "Pushing the Swath
Cloth into Transport Position")
• Fold up the bar. (see section on Operation "Moving the Outer Guards into Transport
Position").
• Lift the rotor until the front and rear locks engage in the retaining bolt (see section on
Operation "Lifting the Rotor Arms to Transport Position").
Note
Make certain the transport locks engage correctly and the actuator rope is not tight.
Swadro 907
The locks (1) on the Swadro 907 have engaged correctly when the white spotlights (2) can be
seen from the tractor with the outrigger arms in vertical position (front rotor and rear rotor).
Swadro 807, Swadro 809, Swadro810
Perform a visual inspection to ensure the locks (1) have engaged correctly.
• Move the hydraulic control unit to neutral position.
• Insert the tine guard onto the tines, which are in transport position below 2 m. (see
section on Operation "Protecting the Tine Tips")
• Check the lighting system.
Pos: 19 /BA/----- Seitenumbruch---- -- @ 0\mod_1 196175311226 _0.doc @ 416 5
To Next Page
Loading...
