Krone Swadro 807 - Adjusting Rear Swath Cloth (Swadro 807;809;810)

Operation
41
Pos: 20.11.1 /B A/Bedienung /Sc hwader/Schwad tuch/Schwadfor mer/Einstelle nd es hinteren Sch wadtuches S wadro 807_80 9_810 @ 76\mod _1309769433 478_78.doc @ 6 64286
8.5 Adjusting the Rear Swath Cloth
(Swadro 807/ 809/ 810)
2
SW810023_2
1
1
3
Pos.I
Pos.II
Fig. 15
Pos: 20.11.2 /B A/Bedienung /Sc hwader/Schwad tuch/Schwadfor mer/Schwadtuc h allgemein @ 2 \mod_1202830 085935_78.doc @ 61884
Note
The swath cloth must be set while the rotor arms are lowered.
The tractor engine must be turned off and the ignition key must be removed.
The distance from the swath former to the rotor can be adjusted for narrow or wide swathing or
to continuously adapt to the amount of forage. The distance from the swath former to the rotor
must be adjusted for the amount of forage.
High amount of forage = long distance
Small amount of forage = short distance
Pos: 20.11.3 /B A/Bedienung /Sc hwader/Schwad tuch/Schwadfor mer/Steckbolze nf ür die Arbeitsst elllung umstec ken @ 78\mo d_131366723 0110_78.doc @ 693473
• For the working position, the socket pin (3) must be reconnected from pos. I to pos. II.
and secured.
Note
The socket pin (3) prevents in pos. I that the swath former comes in contact with the tines of the
rotor.
Pos: 20.11.4 /B A/Bedienung /Sc hwader/Schwad tuch/Schwadfor mer/Schwadtuc h einstellen Sw adro 807_810 @ 7 8\mod_131 3670766215_ 78.doc @ 693500
• To do this, loosen the cone grip and set screw (1), move the swath former (2) to the
correct position and then tighten the cone grip and set screw (1) again.
Pos: 20.11.5 /B A/-----Seitenum bruch------ @ 0\m od_119617531 1226_0.doc @ 4 165