Krone Swadro 807 - Collapsible Tine Arm Operation

Operation
47
Pos: 20.21 /Überschrif ten/Überschrif ten 3/A-E/B eiA usführung Zin kenarm kla ppbar @ 77\mod _1310050676669 _78.doc @ 66 7550
8.8.1 For design with collapsible tine arm
Pos: 20.22 /BA/Be dienung /Sch wader/Zinken / Zin kenarme/Zi nkenarme in die Arb eitsstellung sch wenken @ 2\ mod_12027115 44751_78.doc @ 59954
3
2
1
2
1
SW9070017
Figure 21
• Pull out the linch pin (1).
• Remove the bolts (2).
• Swivel tine arms (3) to working position: the rotor must be turned so that the tine arms do
not collide with the protection when swivelling.
• Insert the bolts (2) and secure with the linch pin (1).
Note
Always insert bolts (2) from above when the tine arms are in front of the rotors (tines touch the
ground).
Take care that the linch pin (1) is always properly engaged (the ring of the linch pin must be
inserted in the groove of the shaft).
Note
Swivel the right collapsible tine arm on the machine side in sequence from behind forwards and
the left collapsible tine arm on the machine side in sequence from the front backwards to the
working position.
Pos: 20.23 /BA/--- --Seitenumbruc h------ @ 0\mo d_119617531 1226_0.doc @ 41 65