Krone Swadro 807 - Warning: Tyre Fitting Incorrect; Checking and Maintaining Tyres

Maintenance
68
Pos: 30.19.1 /Üb erschriften/Üb erschriften 2/P-T/Rei fen @ 0\m od_1197357995 667_78.doc @ 1 8075
10.7 Tyres
Pos: 30.19.2 /B A/Sicherheit/Gefa hrenhinweise/Fals che Reifenm ontage @ 0\ mod_1197358162 433_78.doc @ 1 8132
Warning! - Tyre fitting incorrect
Effect: Injuries or damage to the machine
• Fitting tyres requires sufficient knowledge and the availability of proper tools!
• If tyres are not correctly fitted, it could explode when pumped up. This can cause serious
injury. If you do not have sufficient experience of fitting tyres, have tyres fitted by the
KRONE dealer or a qualified tyre specialist.
• When fitting tyres on the wheel rims, the maximum pressure given by the tyre
manufacturer must not be exceeded. The tyre or even the wheel rim could explode
and/or burst.
• If the tyre heels do not fit properly when the maximum permitted pressure is reached, let
out the air, align tyres, lubricate the tyre heels and pump up the tyre again.
• Detailed information about how to fit tyres onto agricultural machinery can be obtained
from the tyre manufacturers.
Pos: 30.19.3 /Üb erschriften/Üb erschriften 3/P-T/Rei fen prüfen und pflegen @ 0 \mod_1197358 037214_78.doc @ 18094
10.7.1 Checking and maintaining tyres
Pos: 30.19.4 /B A/Wartung/Reife n/Reihenfolg eRei fenmontage @ 0\mod_119 9954083131_78.d oc @ 37321
KLWOA-02
1
3
5
7
9
2
4
6
8
10
Figure 41
When loosening and tightening the wheel nuts, observe the order indicated in the illustration. 10
operating hours after they have been mounted, check the wheel nuts and retighten them if
necessary. After that, check them every 50 operating hours to make certain they are tight.
Check the tyre pressure at regular intervals and refill if necessary. The tyre pressure depends
on the size of the tyres. The values are listed in the table.
Pos: 30.19.5 /B A/-----Seitenum bruch------ @ 0\m od_119617531 1226_0.doc @ 4 165