Operation
51
Pos: 20.31 /BA/I nfo-Center/Schw ader/Einstellen d er Arbeitstief e elektrisch @ 2\ mod_120240 1378131_78.doc @ 59332
SW9070006
4
3
2
1
Fig. 25
The raking height is adjusted during use or in headland position.
Note the following rule:
If the setting is too high, the forage will not be completely collected. If the setting is too low,
there is a danger of the forage being contaminated by dirt, damage to the sward and more wear
on the double spring tines.
The switches (3, 4) are used to set the desired raking height
To do this:
Switch on the controls (1).
Press switch > up = raise rotor
Press switch > down = lower rotor
Pos: 20.32 /BA/--- --Seitenumbruc h------ @ 0\mo d_119617531 1226_0.doc @ 41 65
To Next Page
Loading...
