Chapter 4 Maintaining the Timeclock
4-48 ADP, Inc.
Date/Time Setting (basic configuration)
Use Date/Time Setting to set the date and time on the timeclock display. Note that
you must enter the time in 24-hour format.
Note
These settings are part of the basic configuration of the timeclock. You must
complete these settings when you power up the timeclock for the first time and if
you replace the cover assembly.
Step Display Action
1 Maintenance Mode idle
display
Press the Date/Time Setting soft key.
2 Date (mm/dd/yyyy) Do one of the following:
! Press ENTER to accept the default date.
! Typethedateusingmm/dd/yyyy format, and
press ENTER.
3 Time (24-hour) Do one of the following:
! Press ENTER to accept the default time.
! Typethetimeusinghh:mm format, and press
ENTER.
To Next Page
Loading...