KTM 125 XC-W EU 2017 - Page 14

2 SETUP 12
S01467-01
– Connect the tail light plug-in connector to the main wiring harness plug-in con-
nector.
S01462-10
–
Position the CDI unit, and mount and tighten screws

with the washers.
Info
The wiring harness runs under the CDI unit.
– Position the turn signal cable harness and main wiring harness and secure with
cable ties.
S01465-10
–
Mount the main silencer with rubber sleeve

.
–
Mount and tighten screws

with the washers.
Guideline
Remaining screws, chassis M6 10 Nm
(7.4 lbf ft)
S01464-10
–
Attach the side cover in area

and engage it in area

.
–
Mount and tighten screw

.
Guideline
Screw, subframe M8 35 Nm
(25.8 lbf ft)
Loctite
®
2701™
–
Mount and tighten screw

.
Guideline
Remaining screws, chassis M6 10 Nm
(7.4 lbf ft)
– Install the battery. ( p. 23)
– Install the fuel tank. ( p. 18)
E00496-11
– Position turn signal on both sides, mount nuts with washers and tighten.
– Position license plate lamp on the license plate holder, and mount and tighten
screws

.
–
Mount reflector

on license plate holder .
– Pass cable through the license plate holder.
E00497-11
– Position license plate holder on the license plate holder.
– Connect the plug-in connector of the license plate lamp.
– Connect the plug-in connector of the left turn signal which is marked red.
– Connect the plug-in connector of the right turn signal which is marked green.
–
Mount and tighten screws

.