SERVICE WORK ON THE CHASSIS 11
79
L01223-10
– Now inject the liquid into the system until it emerges from the
drill hole
6
of the master cylinder without bubbles.
– Now and then, extract fluid from the master cylinder reservoir
to prevent overflow.
– Remove the bleeding syringe. Mount and tighten screws
bleeder screw.
– Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container
rim
4 mm (0.16 in)
– Position the cover with the membrane. Mount and tighten the
screws.
Info
Clean up overflowed or spilled brake fluid immediately
with water.
To Next Page
Loading...
