KTM 890 DUKE R User Manual

CONTROLS 6
21
6.10 Tool set
F02791-10
The tool set
1
is located under the passenger seat.
6.11 Grab handle
K01355-10
The grab handle
1
is used for maneuvering the motorcycle.
If you carry a passenger, the passenger can hold onto the grab
handles during the trip.
Info
The vehicle has been set up in the factory for one-person
operation. Only an authorized KTM workshop may carry out
the conversion.
The components for one-person operation and for operation
with a passenger are included in the scope of supply.
Always ensure that the legal requirements are observed,
e.g., entry in the vehicle documents if applicable.
6.12 Passenger foot pegs
V01199-01
The passenger foot pegs can be folded up and down.
Info
The vehicle has been set up in the factory for one-person
operation. Only an authorized KTM workshop may carry out
the conversion.
The components for one-person operation and for operation
with a passenger are included in the scope of supply.
Always ensure that the legal requirements are observed,
e.g., entry in the vehicle documents if applicable.
Possible states
• Passenger foot pegs folded up – For operation without a pas-
senger.
• Passenger foot pegs folded down – For operation with a pas-
senger.

KTM 890 DUKE R Specifications

General

Engine Type	2-cylinder, 4-stroke, parallel twin
Displacement	889 cc
Transmission	6-speed
Seat Height	834 mm
Dry Weight	166 kg
Front Suspension	WP APEX 43
Traction Control	MTC (Motorcycle Traction Control)
Power	121 hp (90 kW) @ 9, 250 rpm
Torque	99 Nm
Fuel Capacity	14 L
Rear Suspension	WP APEX Monoshock
Rear Brake	240 mm disc
ABS	Bosch 9.1 MP (Cornering ABS and Supermoto ABS)
Wheelbase	1, 482 mm
Front Brakes	2 x Brembo Stylema 4-piston radial calipers, 320 mm discs
Frame	Chromium-Molybdenum steel trellis frame