13 SERVICE WORK ON THE CHASSIS
70
402344-01
– Move the handlebar to the straight-ahead position. Align the
lifting gear at the front with the adapters to the fork legs.
Front wheel work stand, small (61129965100)
Info
Always raise the motorcycle at the rear first.
Pay attention to the brake lines.
– Lift the motorcycle at the front.
13.4 Taking the motorcycle off the front lifting gear
Note
Danger of damage The parked vehicle can roll away or fall over.
–
Park the vehicle on a firm and level surface.
312029-10
– Secure the motorcycle against falling over.
– Remove the front lifting gear.
F02736-10
– Position the brake line.
–
Mount and tighten screw
1
.
Guideline
Remaining screws,
chassis
M5 5 Nm (3.7 lbf ft)
13.5 Cleaning the dust boots of the fork legs
Preparatory work
– Raise the motorcycle with the rear lifting gear. ( p. 69)
– Lift the motorcycle with the front lifting gear. ( p. 69)
K01358-10
Main work
–
Push dust boots
1
of both fork legs downward.
Info
The dust boots remove dust and coarse dirt particles
from the inside fork tubes. Over time, dirt can accumu-
late behind the dust boots. If this dirt is not removed,
the oil seals behind can start to leak.
To Next Page
Loading...
