13 SERVICE WORK ON THE CHASSIS
72
13.7 Mounting the passenger seat
K01360-10
–
Hook holding lugs
1
of the passenger seat onto the storage
compartment, lower the rear and push forward.
– Press the passenger seat downward until it clicks into place.
Warning
Danger of accidents The seat can come loose from the
anchoring if it is not mounted correctly.
– After assembly, check whether the seat is correctly
locked and cannot be pulled up.
– Finally, check that the passenger seat is correctly mounted.
Info
The vehicle has been set up in the factory for one-
person operation. Only an authorized KTM workshop
may carry out the conversion.
The components for one-person operation and for oper-
ation with a passenger are included in the scope of
supply.
Always ensure that the legal requirements are observed,
e.g., entry in the vehicle documents if applicable.
13.8 Removing the front rider's seat
Preparatory work
– Remove the passenger seat. ( p. 71)
V01239-10
Main work
–
Remove screws
1
.
– Raise the rear of the front rider's seat, pull the seat back, and
lift it off.
To Next Page
Loading...
