39PERIODIC SERVICE
ENGLISH
LUBRICANTS, FUEL AND COOLANT
Note *1 Oil amount when the oil level is at the upper level of the oil level gauge.
*2 The product name of KUBOTA genuine UDT fluid may be different from that in the Operator's Manual depending
on countries or territories. Consult your local KUBOTA Dealer for further detail.
A To prevent serious damage to hydraulic systems, use only KUBOTA genuine fluid or its equivalent.
Place
Capacities
Lubricants
ZD1011, ZD1021
Fuel 23 L (6.1 U.S. gals.)
No.2-D diesel fuel
No.1-D diesel fuel if temperature is below
-10 (14 )
Coolant 2.7 L (2.85 U.S.qts.)
Fresh clean water with anti-freeze
Recovery tank 0.25 L (0.26 U.S.qts.)
Engine crankcase 3.5 L (3.7 U.S.qts.)*1
Engine oil: API service
Classification CF or better
Above 25 ...SAE30, SAE10W-30 or 15W-40
(77 )
0 to 25 .........SAE20, SAE10W-30 or 15W-40
(32 to 77 )
Below 0 ........SAE10W, SAE10W-30 or 15W-40
(32 )
Transmission case with filter & hose
Rear axle gear case (RH &LH)
7.5 L (7.9 U.S.qts.) KUBOTA SUPER UDT-2 fluid*2
Mower gear box 0.4 L (0.42 U.S.qts.)
Engine oil: API service Classification SH, SJ or higher
SAE10W-30
Greasing No. of greasing points Capacity Type of grease
Front axle 2 Until grease
overflows
Multi purpose
EP2 Grease
(NLGI Grade No. 2)
Front wheel 2
Parking brake lock pedal 1
Front lift arm 2
Universal joint 3
Seat adjuster 2
Cable (throttle cable, mower lift cable) 3 Moderate amount Oil
Motion control lever pivot bushing,
and contact position
6
[MOWER]
Universal joint 3 Until grease
overflows
Multi purpose
EP2 Grease
(NLGI Grade No. 2)
Three spindle shafts 3
Belt tension pulley 1
Belt tension pivot 1
Anti scalp roller 1
Front anti scalp roller pivot boss 2
To Next Page
Loading...
