MAINTENANCE62
ENGLISH
EVERY 1000 HOURS or EVERY 1 YEAR
Replace every 1000 hours or every 1 year whichever
comes faster.
BReplacing Air Cleaner Primary Element
and Secondary Element
(See "Cleaning Air Cleaner Primary Element" in "EVERY
100 HOURS" in "MAINTENANCE" section.)
A To prevent serious damage to the engine, use only a
KUBOTA genuine filter.
[How to remove the secondary element]
1. While turning slightly, pull out the secondary element.
EVERY 1500 HOURS
BChecking Fuel Injection Nozzle (Injection
Pressure)
Consult your local KUBOTA Dealer for this service.
EVERY 2000 HOURS or EVERY 2 YEARS
Be sure to do the following service once every 2000 hours
or every 2 years whichever comes faster.
BFlushing Cooling System and Changing
Coolant
To avoid serious injury or death:
A Do not remove the radiator cap when the
engine is hot. Then loosen cap slightly to the
stop to relieve any excess pressure before
removing cap completely.
1. Stop the engine and let cool down.
2. To drain the coolant, open the radiator drain valve and
remove the radiator drain plug and remove radiator
cap. The radiator cap must be removed to completely
drain the coolant. (See the following figure.)
3. After all coolant is drained, close the drain valve and
install the drain plug.
4. Fill with clean water and cooling system cleaner.
5. Follow directions of the cleaner instruction.
6. After flushing, fill with clean water and anti-freeze until
the coolant level is just below the fill port on the
radiator.
Install the radiator cap securely.
7. Fill with coolant up to the "FULL" mark on the recovery
tank.
8. Start and operate the engine for a few minutes.
9. Stop the engine and let cool.
10.Check coolant level of recovery tank, add coolant if
necessary.
(1) Secondary element
To Next Page
Loading...
