Kubota ZD1021 - Battery Troubleshooting; Machine Troubleshooting

78 TROUBLESHOOTING
ENGLISH
BATTERY TROUBLESHOOTING
If you have any questions, contact your local KUBOTA Dealer.
MACHINE TROUBLESHOOTING
Trouble Cause Countermeasure Preventive measure
Starter does not function.
A Battery overused until
lights are dim.
A Charge battery
sufficiently.
A Charge the battery properly.
A Battery has not been
recharged.
A Poor terminal
connection.
A Clean the terminal
and tighten securely.
A Keep the terminal clean and
tight.
Apply grease and treat with
anti-corrosives.
A Battery life expired. A Replace battery.
From beginning starter
does not function, and
lights soon become dim.
A Insufficient charging. A Charge battery
sufficiently.
A Battery must be serviced
properly before initial use.
A Insufficient charging. A Adjust fan belt.
When viewed from top,
the top of plates look
whitish.
A Battery was used with
an insufficient amount
of electrolyte.
A Add distilled water
and charge the
battery.
A Regularly check the
electrolyte level.
A Battery was used too
much without
recharging.
A Charge battery
sufficiently.
A Charge the battery properly.
Recharging is impossible.
A Battery life expired. A Replace battery.
Terminals are severely
corroded and heat up.
A Poor terminal
connection.
A Clean the terminal
and tighten securely.
A Keep the terminal clean and
tight.
Apply grease and treat with
anti-corrosives.
Battery electrolyte level
drops rapidly.
A There is a crack or pin
holes in the electrolytic
cells.
A Replace battery.
A Charging system
trouble.
A Contact your local
KUBOTA Dealer.
Trouble Cause Countermeasure
Machine operation is not
smooth.
A Hydrostatic transmission fluid is
insufficient.
A Fill oil.
A Filter is clogged. A Replace the filter.
Machine dose not move while
engine is running.
A Parking brake is on. A Release the parking brake.
A Transmission fluid level is
insufficient.
A Fill oil.
Machine moves when motion
control levers are in "NEUTRAL
LOCK" position.
(Engine is operated.)
A Hydrostatic lever is not correctly
adjusted.
A Consult your dealer for hydrostatic lever
linkage adjustment or pressure
adjustment.
A Control linkage pivots are sticking. A Full up and lubricate linkage.