After entering this information, it is necessary to save these
settings. To do so, type:
@SAVE,A (or @SAVE,B if this data is for Satellite 2)
@DEBUGOFF
After completing this process, restart the system by either cycling
power or typing
ZAP in the maintenance screen.
One of your user-defined satellite options has now been added to
the TracVision 4 satellite library. This option will now be
available as USER1 the next time the SATINSTALL command is
given. If a second satellite is added, it will appear as USER2 in
the SATLISTA list.
An Example of Configuring a User-defined Satellite
The following is an example of configuring the fictional
YOURSAT 101 as the USER1 configured satellite. Prior to
configuring this satellite or any others, be certain to get the most
up-to-date information from one of the sources previously
discussed.
Yoursat 101 at 7 West, DVB decoder, Linear Polarization LNB
Horizontal High
Frequency 11.966 GHz
Symbol Rate 27500
FEC Code 3/4
Network ID 2048 (dec) = 0x0800
Vertical High
Frequency 11.823 GHz
Symbol Rate 27500
FEC Code 3/4
Network ID 2048 (dec) = 0x0800
Vertical Low
No Data Listed
Horizontal Low
No Data Listed
2-19
Installation
54-0150 Rev. E
Table 2-10
Sample Satellite
Configuration Data
To Next Page
Loading...
Need help?
General
