54-0147
50
TracVision G4 Technical Manual
5. Repeat Step 4 for each of the following
transponder categories:
• vertical high • vertical low
• horizontal high • horizontal low
OR
• right • left
TracVision G4 requires that the data fields for all
transponder categories be provided. If the selected
satellite does not have information for one or more of
the transponder categories, default information should
be entered in the fields as follows:
Transponder Data Default Value
Frequency 00000
Symbol Rate 27500
FEC Code the same value as provided for those
transponders with data
Network ID 0x0000
Polarity and Band whichever combinations are not
already provided
6. After entering all of the necessary information,
save the settings by typing
@SAVE,A<cr> (or B if
the data is for satellite User 2).
7. Type
ZAP<cr> to restart the antenna.
8. If you need to configure a second user-defined
satellite, repeat this procedure starting with Step 1
to enter data for the USER2 satellite.
You have now added your user-defined satellite(s) to the
system’s satellite library. The first user-defined satellite you
configured is stored as USER1. If you configured a second
satellite, it is stored as USER2.
If you want the antenna to track one or both of these user-defined
satellites, you need to install it. To install a satellite, you can use
either the ADCU, as described in “Installing Your Selected
Satellites” on page 45, or you can use the SATINSTALL command,
as described on the following page.
Table 2-13
Satellite Transponder
Default Data
To Next Page
Loading...
Need help?
General
