15
Follow the steps below to set up the system for
your desired satellite TV service and test the
system for proper operation.
a. Park the vehicle in a blockage-free area. The
antenna requires an unobstructed view of the
southern sky to receive satellite signals.
b. DISH Network or Bell TV only:
Follow the step-by-step setup instructions
provided in the User’s Guide to configure
your DISH Network or Bell TV receiver(s) for
your selected TracVision mode.
c. Turn on the receiver(s) and TV(s). For details
on operating the receiver, refer to your
selected receiver’s user manual.
d. Set the switchplate’s POWER switch to the
ON (
|
) position (see Figure 23). Within a few
minutes, a picture should appear on the TV.
e. TracVision R5SL only - Take a road test to
verify the antenna tracks the satellite while
the vehicle is moving.
f. When you have finished testing, set the
switchplate’s POWER switch to the OFF (O)
position. Be sure to leave the Welcome Kit
inside the vehicle for the customer, and place
any unused service keys inside the kit.
Each DISH Network or Bell TV receiver must
be configured to work with the TracVision
system, as explained in the User’s Guide.
IMPORTANT!
Figure 23: Switchplate ON/OFF Switch
MAINTENANCE
OFF
ON
Set Up and Test the System
13
To Next Page
Loading...
Need help?
General
