IDLE SPEED ADJUSTMENT
A diagnostic tachometer must be used for
this procedure.
1. Start the engine and warm it up for a few
minutes at approximately 1,000 to 2,000
r/min. Occasionally rev the engine to
4,000 to 5,000 r/min. The engine is warm
when it quickly responds to the throttle.
2. Connect the tachometer and set the idle
to the specified idling speed by adjusting
thethrottlestopscrew.Turnthescrewin
to increase engine speed, and out to
decrease engine speed.
Specified idle speed: 2000 RPM
NOTE:
(1) Throttle stop screw
(1)
95
To Next Page
Loading...
