9. CLUTCH/GEAR SHIFT MECHANISM
Install the oil filter rotor.
Install the washer and tighten the square nut.
Torque: 4.0～5.0kg-m
Install the special flange gasket onto the
balance shaft driven gear with the flange
facing down and then loosely install the
square nut (left hand threads).
Tighten the square nut using the square
socket.
Install the oil filter rotor cover.
Check the gasket for wear or damage and
replace if necessary.
Install and tighten the three oil filter rotor
cover screws.
Torque: 0.3～0.4kg-m
Install the oil pump gear cover and tighten
the two bolts.
RIGHT CRANKCASE COVER
INSTALLATION
First install the dowel pins and then install
the gasket.
Install the right crankcase cover and tighten
the cover bolts.
Torque: 0.8～1.2kg-m
Install the washer with the mark
“OUTSIDE” facing up.
Tighten the right crankcase cover bolts
diagonally.
To Next Page
Loading...
