10-16
Troubleshooting > Responding to Messages
D
E
Cannot staple at the specified
position.
Have you selected a position that
cannot be stapled?
Press [Paper Selection] to select the
available paper.
Press [Continue] to print without using
Staple function.
—
Cannot staple the following
paper.*
Did you select a paper size/type
that cannot be stapled?
Press [Paper Selection] to select the
available paper.
Press [Continue] to print without using
Staple function.
—
Cassette # failure. — Contact your Service Representative.
Press the System Menu/Counter key,
[Adjustment/Maintenance], [Service
Setting] and then [Enable Repaired
Unit]. Press [Execute] to perform Enable
Repaired Unit.
—
Check the document processor. Is the document processor
open?
Close the document processor. —
Check waste toner box. Is the waste toner box full? Replace the waste toner box. 10-4
— The waste toner box is not installed
correctly. Set it correctly.
10-4
Cleaning the laser scanner… — The machine is under the adjustment to
maintain its quality. Please wait.
—
* When Auto Error Clear is set to [On], processing resumes automatically after a set amount of time elapses.
Message Checkpoints Corrective Actions Reference
Page
Developer unit is not installed.
[C][M][Y][K]
— Replace the developer unit (g) to our
specified developer unit. See the leaflet
supplied with the developer unit.
—
Drum unit is not installed.
[C][M][Y][K]
— Replace the drum unit (f) to our
specified drum unit. See the leaflet
supplied with the drum unit for details.
—
Message Checkpoints Corrective Actions Reference
Page
Error occurred at cassette #. — Remove the indicated cassette. Press
[Next >] to follow the instructions.
—
Message Checkpoints Corrective Actions Reference
Page
To Next Page
Loading...
Need help?
General