2PG/2PH
1-6-4
6. Confirm that downloading was finished nor-
mally (See previous page).
7. Turn power off.
8. Remove the memory card.
9. Secure the optional interface slot cover by
using two screws.
10. Close the rear cover.
11. Turn power on again.
Check the printer gets ready and Ready
indicator is lit.
12. Print a status page (See page P.1-3-2).
13. Confirm the status page shows the new
firmware version.
Figure 1-6-5
Screw
Optional interface
slot cover
Screw
Memory card
Memory card slot
To Next Page
Loading...
