9-11
Troubleshooting > Troubleshooting
Printouts are curled. Is the paper damp? Replace the paper with new paper. page 3-2
Cannot print. Is the machine plugged in? Plug the power cord into an AC outlet. ―
Is the machine powered on? Turn on the power switch. page 2-9
Are the USB cable and network cable
connected?
Connect the correct USB cable and
network cable securely.
page 2-7
Cannot print with USB
memory.
USB memory not
recognized.
Is the USB host blocked? Select [Unblock] in the USB host
settings.
page 7-25
― Check that the USB memory is securely
plugged into the machine.
―
Dirt on the top edge or back
of the paper.
Is the interior of the machine dirty? Clean the interior of the machine. page 9-2
Part of the image is
periodically faint or shows
white lines.
― Open and then close the rear cover. page 2-2
― Select the [Menu] key > [Adjust/
Maintenance] > [Service] > [MC] and
decrease the adjustment value.
Decrease the adjustment value 1 level
at a time from the current value. If there
is no improvement after the value is
decreased by 1 level, decrease by 1
level again. If there is still no
improvement, return the setting to the
original value.
―
Skewed-color printout. ― Run [ColorCalibration]. page 9-21
― Run [Color Regist.]. page 9-21
Colors appear different than
you anticipated.
When printing from a computer
Adjust the color using the printer driver.
―
The previous image remains
and lightly printed.
― Select the [Menu] key > [Adjust/
Maintenance] > [Service] > [MC] and
increase the adjustment value. Increase
the adjustment value 1 level at a time
from the current value. If there is no
improvement after the value is
increased by 1 level, increase by 1 level
again. If there is still no improvement,
return the setting to the original value.
―
Symptom Checkpoints Corrective Actions
Reference
Page