Management
OPERATION GUIDE 11-3
11
Use the procedure below to enable user login administration.
NOTE: Refer to Character Entry Method on Appendix-5 for details on entering characters.
1 Press the System Menu/Counter key on the main
unit operation panel.
If user login administration is disabled, the user
authentication screen appears. Enter your login
user name and password and then press [Login].
For this, you need to log in with administrator
privileges. Refer to Adding a User on page 11-6 for
the default login user name and password.
NOTE: If [Netwk Authentic.] is selected as the user
authentication method, press [Menu] (the Left Select
key) to select the authentication destination.
2 In the Sys. Menu/Count. menu, press the U or V
key to select [User/Job Account].
3 Press the OK key. The User/Job Account menu
appears.
4 Press the U or V key to select [User Login Set.].
5 Press the OK key. The User Login Set. menu
appears.
6 Press the U or V key to select [User Login].
Login User Name
L
b
*******************
Login Password:
[ Menu ] [ Login ]
Sys. Menu/Count.:
a
b
*********************
5
User Property
6
Common Settings
[ Exit ]
4
User/Job Account
User/Job Account:
a
b
*********************
2
Job Account. Set.
3
Unknown ID Job
[ Exit ]
1
User Login Set.
User Login Set.:
a
b
*********************
2
Local User List
[ Exit ]
1
User Login
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
