Kyocera FS-1300D - Operation Panel

2H5/2HS
1-3-4
Service items Description
Code conversion
ABCDEF GHI J
0123456789
No. Items Description
 Engine ROM information [Flash ROM version]
 Boot ROM information [Boot ROM version]
 Software jumper switch
information
(hexadecimal)
[First byte/Second byte
(displayed in OEM model
only)]
First byte
bit 0 = 1: (Fixed)
bit 1 = 0: Overseas, 1: Domestic (Japan)
bit 2, 3 (Not used)
bit 4 = 0: Kyocera, 1: OEM
bit 5 = 0: For Europe, 1: For US
bit 6 = 0: Non MICR mode, 1: MICR mode
bit 7 (Not used)
Second byte: Displayed in OEM model only
 Tota l pa g e -
 Toner install information -
 USB information 00: Not connected
01: Full-Speed
02: Hi-Speed
 Operation panel lock sta-
tus (displayed only when
locked)
01: Partial lock
02: Full lock
 NVRAM error (displayed
only when any error has
occurred)
01: ID error
02: Version error
03: Checksum error
04: NVRAM crush error
 Printable area setting /Top offset/Left offset/Page length/Page width
 Left offset for each paper
source
/MP tray/Cassette1/Cassette 2/Cassette 3/Duplex
(1/600 inches unit)
 Top offset for each paper
source
/MP tray/Cassette 2/Cassette 3/Duplex
(1/600 inches unit)
 Offset for rotation /Top offset/Left offset/
(1/600 inches unit)
 Optional paper feeder ver-
sion
/Paper feeder 1/Paper feeder 2/
 Calibration table setting Setting value (FRPO I4), Hexadecimal
 Resolution Current value of bit-per-pixel
 Copy quantity -
 Installed device/function
information
bit0: HDD
bit1: Optional ROM
bit2: Memory card
bit3: USB memory
bit4: HDD security
 Operation panel message
language
PMSG command setting (decimal)
 Current temperature
0 to 50 °C/32 to 122 °F (in 1 °C/1.8 °F increment, “-” = Temperature sensor
is abnormal.)