EasyManuals Logo

Kyocera FS-1920 Installation Guide

Kyocera FS-1920
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
9
Connecting the Power Cord
This section describes the procedure for connecting the power cord and various cau-
tions.
Notes on Power Supply
Install the printer near an AC wall outlet, preferably one that can be used for
the printer alone.
Only use this printer with the supply voltage indicated on the serial number
label attached to the printer’s rear panel.
If an extension cord is used, the total length of the power cord plus extension
should be 5 meters (16 feet) or less.
Power Requirements
To Connect the Power Cord
Be sure the printer’s power switch is turned off.
Only use the power cord supplied with the printer.
1 Plug the power cord into the power cord
connector on the rear of the printer.
2 Connect the other end of the power cord
into a power outlet.
Be sure to connect to a 3-wire
grounded power strip.
Voltage
120 V (U.S.A. and Canada), 220 to 240 V(European countries,
and the Asia Pacific region), ±10 % at each voltage
Frequency
60 Hz (120 V) ±2 %, 50/60 Hz (220 to 240V) ±2 %
Current capacity
8.0 A at 120 V, or 3.9 A at 220 to 240 V
STEP
6
Power Cord
Connector
Power Cord
FS-1920IG.book 9 ージ 204年月1日 曜日 午前0時1分

Other manuals for Kyocera FS-1920

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kyocera FS-1920 and is the answer not in the manual?

Kyocera FS-1920 Specifications

General IconGeneral
Print TechnologyLaser
Resolution600 x 600 dpi
Warm-up Time15 seconds
Time to First Page9 seconds
Processor Frequency200 MHz
TypeMonochrome Laser Printer
Supported Operating SystemsWindows, Mac OS, Linux
ConnectivityUSB 2.0
Memory32 MB
Output Capacity250 sheets

Related product manuals