EasyManuals Logo

Kyocera FS-1920 Installation Guide

Kyocera FS-1920
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
Caution
No liability is assumed for any damage caused by improper installation.
Notice on Software
Software used with this printer must support the printer’s emulation mode. The printer is factory-set to emulate
the HP PCL 6. The emulation mode can be changed by following the procedures described in the Operation
Guide contained as an electronic file in the CD-ROM supplied with the printer.
Notice
The information in this manual is subject to change without notification. Additional pages may be inserted in
future editions. The user is asked to excuse any technical inaccuracies or typographical errors in the present
edition.
No responsibility is assumed if accidents occur while the user is following the instructions in this manual. No
responsibility is assumed for defects in the printer’s firmware (contents of its read-only memory).
This manual, any copyrightable subject matter sold or provided with or in connection with the sale of the page
printer, are protected by copyright. All rights are reserved. Copying or other reproduction of all or part of this
manual, any copyrightable subject matter without the prior written consent of Kyocera Mita Corporation is pro-
hibited. Any copies made of all or part of this manual, any copyrightable subject must contain the same copy-
right notice as the material from which the copying is done.
Table of Contents
STEP 1 Unpacking ......................................................................... 1
STEP 2 Positioning the Printer ..................................................... 2
STEP 3 Installing the Toner Container ......................................... 3
STEP 4 Installing the Waste Toner Box........................................ 5
STEP 5 Connecting the Printer to the Computer ........................ 7
STEP 6 Connecting the Power Cord ............................................ 9
STEP 7 Adding Paper to the Paper Cassette and MP Tray....... 10
STEP 8 Turning the Power Switch On ........................................ 18
STEP 9 Printing a Status Page.................................................... 19
©2003, 2004 by KYOCERA MITA CORPORATION All rights reserved.
Revision 1.1 January 2004
FS-1920IG.book 1 ージ 20  

Other manuals for Kyocera FS-1920

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kyocera FS-1920 and is the answer not in the manual?

Kyocera FS-1920 Specifications

General IconGeneral
Print TechnologyLaser
Resolution600 x 600 dpi
Warm-up Time15 seconds
Time to First Page9 seconds
Processor Frequency200 MHz
TypeMonochrome Laser Printer
Supported Operating SystemsWindows, Mac OS, Linux
ConnectivityUSB 2.0
Memory32 MB
Output Capacity250 sheets

Related product manuals