Setting the Paper Type
2-54
3. Press the
4
key after selecting the paper type you want to customize. Pressing the + or −− keys will
cycle through a display of the submenus given in the table below.
Submenus displayed Selection parameters Description
>>Paper weight Light(Thin)
Normal (default)
Heavy (Thick)
Sets the paper thickness
>>Fuser mode Vellum
Low
Middle (default)
High
Sets the temperature for the fusing
unit.
>>Duplex path
(only when the paper type
is Custom #)
Enable (default)
Disable
Selects duplex printing on/off when
a DU-30/DU-31 is installed (setting
active only for the selected paper
type)
Display the submenu to be set and press the ENTER key. A ? will flash. Press the + or −− keys to
select the desired parameter.
>>Paper weight
? Normal
(Example: Setup menu for Paper weight)
Press the CANCEL key if you want to cancel the setting. The ? will disappear.
To Next Page
Loading...
