Chapter 2 Operating the Page Printer
2-27
Configuring Interfaces
The printer is equipped with both a parallel and serial interface. Independent settings can be made for
each interface. Optional interfaces can also be installed.
To configure each interface, press the MODE key and use the + or – key to select the interface you
wish to make settings for.
Note _____________________________________________________________________
This interface selection does not select which interface data will be received from. The printer
automatically selects that interface.
Parallel Interface
The parallel interface mode of this printer supports a bi-directional/high-speed mode. Normally, this
interface is used under the default setting Nibble (high), see Appendix C. After setting the
interface, be sure to reset the printer or turn the power off at least once. The new setting will be
enabled thereafter.
To Next Page
Loading...
