Kyocera FS-7000+ - Mode Selection Menu

Mode Selection Menu
2-24
Mode Selection Menu
This section explains the menu hierarchy used for all menus which can be set and selected using the
MODE key. The MODE key can be used to display all of the menus in the table below. This mode
selection menu conforms to the menu hierarchy given at the end of this manual.
Pressing the MODE key initially displays menus at the top of the hierarchy.
Use the + and – keys to move between menus in the same level. The + key shows the next menu,
while the – key shows the previous one. Change levels by using the
3
and
4
keys. The
4
key moves
to lower levels (sub-menus), while the
3
key moves to higher levels.
Mode Selection Menu List
Menu Description Default Setting
Interface >
Selects the interface for which settings are to be made.
Settings from the mode select menu are applied to the
interface selected here.
Parallel
• Depending on the computer connected, you can select
from any of Nibble (high), Auto, Normal,
High Speed.
Nibble (high)
• The following settings can be made for the serial
interface.
Baud rate 9600
Data bit 8
Stop bit 1
Parity None
Protocol
Barcode mode
DTR (pos.) & XON
Off
(Continued on next page)