Chapter 1 Installing the Page Printer
1- 41
Expanding Memory
The printer comes standard equipped with 8 MB of main memory. However, more complex pages can
be printed and processing speed increased by expanding the printer's memory. There are two slots
available in the printer for expanding memory. Printer memory can be expanded to up to 72 MB by
installing optional extended memory chips (SIMMs) in these slots.
Note _____________________________________________________________________
The expansion memory should be installed only by a Kyocera authorized dealer or Kyocera certified
technician. Kyocera shall not be liable for damage due to improper installation of the expansion
memory.
Memory Required by the Printer Environment
It may be necessary to extend memory depending on the operating environment of the printer. Please
refer to the table below for minimum memory requirements in various environments.
Minimum Memory Required
Resolution: 300 dpi Resolution: 600 dpi
HP LJ 5M/5Si (factory setting) 8 MB 8 MB
HP LJ 5M/5Si, duplex mode = on* 8 MB 8 MB
HP LJ 5M/5Si, duplex mode = off
Resource protection
— 10 MB
HP LJ 5M/5Si, duplex mode = on*
Resource protection
— 14 MB
KPDL, duplex mode = off 8 MB 8 MB
KPDL, duplex mode = on 8 MB 12 MB
*An optional duplex unit (DU-30/DU-31) is required for duplex printing.
Note _____________________________________________________________________
When printing on paper larger than A4 size, it may be necessary to extend memory depending on the
size of data to be printed.
Printing Environment
To Next Page
Loading...
