Kyocera FS-7000+ - Mode Select Menu

>Barcode mode
Off
Mode Select Menu
Basic Operations During Mode Selection
This diagram gives quick reference to all
menu options and their sequence of
selection. Use this description in
combination with Chapter 2 Mode
Selection Menu.
1. Press the MODE key to enter Mode
Selction mode.
2. Press the + or – key repeatedly until the
message display indicates the desired
item.
3. Press the
8
key to move to a submenu.
Press the
w
key to return.
4. Press the ENTER key once the desired
menu appears. ? will flash, and the
current setting can be changed.
5. Press the + and – key to select the
desired setting.
6. Press the ENTER key.
If you want to re-enter a setting, press
the CANCEL key before pressing the
ENTER key.
7. Press the EXIT key. This will enable
currently selected settings.
These items willl not show unless the
printer is installed with the applicable
option unit/kit.
Normal
High Speed
Auto
>Parallel I/F
Nibble (high)
>Data bits
8
>Stop bits
1
>Parity
None
>Protocol
DTR (pos.)&XON
Ready
PAR 600 A4 001
>TCP/IP
Off
>Ether Talk
Off
>TCP/IP
Off
>OPT. StatusPage
Off
Number of copies
001
>>Subnet Mask
>>Gateway
>>IP Address
>>DHCP
OFF
>>NetWare Frame
Auto
Option2
Option1
Serial
Interface >
Parallel
Continued on next page
>Baud rate
9600
>
On
>TCP/IP
Off
>
On
>NetWare
Off