Appendix C Host Computer Interface
C-15
H4: Parity
Parameter value Meaning
0 None
1 Odd
2 Even
3 Ignore
The factory setting is “None” (0 on the status printout).
H5: Protocol logic
Parameter value Meaning
0 Combination of 1 and 3 below
1 DTR/DSR, positive logic
2 DTR/DSR, negative logic
3 XON/XOFF
4 ETX/ACK
5 XON/XOFF recognized only as protocol
The factory setting is 0.
Note _____________________________________________________________________
Since DTR/DSR protocol is not used with the RS-422A standard, select a parameter value other than
0, 1, or 2 for the H5 setting when using the RS-422A interface.
H6: Buffer nearly-full threshold
This is a percentage from 0 to 99. The factory setting is 90.
To Next Page
Loading...
