The Multi-Purpose Tray
1- 38
3. Check that the message Ready is displayed in the printer's message display, and that the ON
LINE indicator is lit.
4. Set the paper source to the multi-purpose tray by pressing the FEED key until the message
display indicates MP tray. The multi-purpose tray indicator on the control panel will flash, and
Add paper will be displayed.
5. Press the MODE key. Then use + or – keys to display Paper handling >.
6. Press the
4
(Form Feed) key to display >MP tray size or > MP tray type, then
press the ENTER key so you can set the paper size or type to be fed from the multi-purpose
tray. See Mode Select Menu at the end of this manual.
The manner in which paper is fed in each of these modes is explained below.
First mode
1. Press the MODE key. Then use + or – keys to display Paper handling >.
2. Press the
4
(Form Feed) key to display >MP tray mode.
3. After pressing the ENTER key, the mode display is changed by pressing the + and – keys.
Display First and then press the ENTER key.
>MP tray mode
First
4. Press the EXIT key.
Note _____________________________________________________________________
In this mode, the paper source indicator on the control panel does not change while paper is being fed
from the multi-purpose tray.
To Next Page
Loading...
