Chapter 1 Installing the Page Printer
1- 47
Testing Extended Memory
1. Check that the power switch is off, plug the power cord into the printer, and turn the power on.
2. Wait for the printer's ON LINE indicator to light and the message display to read Ready, and
press the STATUS key.
3. If installation has been performed properly, a status page will be printed. Check the Available
Memory Item in the upper right. Information on the SIMMs installed in slot 1 and slot 2 is shown
here. There is no problem if total memory has increased. (The printer is shipped from the
factory with 8192 KB [8 MB] of memory.)
To Next Page
Loading...
