18
After changing the printer setting, press [End] button the recover the printer to online
status, then turn OFF/ON the main switch.
It is only after turning the main switch OFF/ON, the printer setting will be reflected.
(3) Network settings
It is possible to set the Internet Protocol (IP) address, Subnet Mask and Gateway
address.
* These settings should be performed by the network manager or under that per-
son’s instruction.
After changing the printer setting, press [End] button the recover the printer to online
status, then turn OFF/ON the main switch.
It is only after turning the main switch OFF/ON, the printer setting will be reflected.
Press the “Network setting” key.
The Pin code screen will appear.
Make sure that “Off line” is shown in the message display (the printer is currently off-
line) and press the “Default” key. The printer setting screen will appear.
1
2
2
6. Printer Configuration
If KPDL (AUTO) is selected at step 1, the Alternate Emulation option will appear. This
allows you to select an alternate emulation mode in cases when no print can be made
in KPDL mode.
To Next Page
Loading...
