Kyocera KM-4230

2-17
2. Printer Driver for WindowsNT
EE
EE
E:[Staple]
If the optional finisher is installed, this attribute allows you to staple your document in one of four ways: Front, Center, Back or saddle stitch.
* All staple options are disabled when Transparency is selected.
*[Staple] allows only originals size of Ledger, Legal, letter, A3, A4, B4 JIS and B5 JIS. If these papers are not selected, the staple mode
will be grayed.
* It Group sort is selected, the staple mode should be OFF and grayed.
FF
FF
F:[Punch]
If the optional finisher and punch unit are installed, this attribute allows you to punch holes on the on the long edge or short edge of the
document you can choose are of the following options.
*[Punch] allows only originals sizes of Ledger, Legal, Letter, A3, A4, B4 JIS and B5 JIS. If these papers are not selected, the staple mode
will be grayed.
A A AAA
Front Center Rear Booklet Stitch
A A A
2 holes
3 holes 4 holes