Kyocera TASKalfa 305 - Transfer;Separation Section; Detaching and Refitting the Transfer Roller Unit

2K3/2L3
1-5-20
1-5-6 Transfer/separation section
(1) Detaching and refitting the transfer roller unit
Procedure
1. Open the right cover 1.
(See page 1-5-11)
2. Release two lock levers (yellow) and
then remove the transfer roller unit.
3. Check or replace the transfer roller unit
and refit all the removed parts.
CAUTION: Inserting the transfer roller
unit in place until it click in,when refitting
the transfer roller unit.
Figure 1-5-33
Lock lever(yellow)
Lock lever(yellow)
Transfer
roller unit